WMF Quality One lid handle repair
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement ring and flange for a broken WMF Quality One lid handle. Uses an M5 insert and M5 worm screw.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 20
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The lid of my WMF Quality One pot fell to the floor, and the main plastic parts of the handle broke. Since I didn’t want to throw away an otherwise perfectly good lid, I reverse engineered the missing parts and designed replacements.
What’s included
Ring
Flange piece (with a pocket for an M5 brass insert)
What you need
1× M5 brass insert (installed in the flange piece)
1× M5 grub screw, 14 mm long
Print settings
Printer: Prusa MK4S
Material: [PETG / ASA: heat resistance matters near a hot pot lid]
Layer height: variable layer height (auto mode)
Infill: 15%
Perimeters: at least 4, because the screw sits inside the lid and puts load on the part
Supports: yes
Notes
Check the fit against your own lid before printing, as dimensions may vary between production years.
The handle sits close to a hot lid, so use a material with sufficient heat resistance.
This is not an official WMF part, and the model is not affiliated with WMF. Use at your own risk.