FLSUN QQS Pro top cap plug + BTT SFS V2.0 filament sensor mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Fills the QQS Pro top-cap cutout left by the stock extruder arm and holds a BTT SFS V2.0 filament sensor.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 16
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
When I converted my FLSUN QQS Pro to direct drive (a Sherpa Mini on the effector), the stock grey extruder arm came off. That left an L-shaped cutout in the edge of the black top cap. This part fills that cutout so it sits flush with the top and the side skirt. Underneath it holds a BTT SFS V2.0 filament sensor in line with the filament path:
spool → hole in the top plate → sensor → PTFE tube down to the toolhead
Fit It fits my printer's cutout perfectly: 50 mm wide, 30 mm into the top face and 40 mm down the skirt. It bolts up through the sheet's existing two holes, so you don't need to drill anything. There's a small pocket above the sensor's top push-fit, so you can still get tweezers in to lift the collet.
Heads up on alignment I don't run a tube into the top. I couldn't get it lined up nicely, so the filament feeds straight in through the hole. The top hole, the sensor's push-fits and the slot underneath aren't perfectly in line. It's a bit janky. Feeding bare filament works fine for me. To load, cut the filament end at an angle, straighten the tip and twist it as you push. If you want a Bowden tube on top, expect some fiddling.
Hardware
2× M4×10 hex bolts and 2× standard M4 nuts (7 mm across flats). The stock bolts are too short to catch the nut, and flanged nuts won't fit the pockets. What I actually did: I only had very long M4s, so I superglued M3 nuts into the M4 holes instead. It holds fine.
2× M3×8 socket-head screws. They go in through the leg into the sensor's top two threaded inserts. The third, lower insert isn't used.
BTT SFS V2.0 filament sensor
Printing Print it lying on its end face, as the STL is oriented. The whole profile is then in the layer plane, so it needs no supports and the bolt loads run along the layers. I printed mine in PLA with my normal settings.
