1 / 5
Milkometer 3000 — zdjęcie 1
1 / 5

Milkometer 3000

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A magnetically mounted status slider to inidcate if the milk is empty or not.

Ocena
0 / 5
Polubienia
1
Pobrania
1
Wydruki
0
Wyświetlenia
45
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Milkometer 3000

At work we have a fully automatic coffee machine, which is fantastic!

Unfortunately it does not detect if the milk powder container is empty and there is no easy way to check the powder level from the outside. When then requesting a cappuccino, the machine proceeds to grind and brew the coffee, only to then thin it down with cloudy water instead of delicious milk foam.

To prevent myself and colleagues from, one after another,  wasting perfectly good coffee beans, I designed the Milkometer 3000. This way the first person to encounter a non-milky coffee can signal everyn

Due to my humble CAD skills and keeping 3d printing as simple as possible, superglue is needed for the final assembly.

Printing guide

I suggest using PLA with a maxmimum nozzle size of 0.4mm.

PETG or other filaments should be fine too though. I would not go over a nozzle size of 0.4mm. This will likely cause issues with the logo click fit and or the washers recesses. 

Required Tools

  • Soldering iron (for placing threaded inserts)

  • Super glue 

Bill of Materials

3d printed parts
  • Frame 

  • Carriage

  • Knob

  • Milk logo base x 2 (ideally in different colour)

  • Milk logo frame x 2

Magnets
  • 2x Strong rectangular magnets - 20 x 10 x5 mm³ 

  • 1-2 round magnets - radius 2,5 mm, height 2,5 mm

Other materials
  • 1-2 x Washers 

    • outer radius < 3,5 mm

    • inner radius > 1,4 mm

    • thickness  < 0,7 mm

  • M3 10mm countersunk threaded screw

  • M3 threaded insert

Assembly

Once all materials have been obtained/printed, the following assembly steps are needed. When glueing the magnets, I recommend doing this one at a time and waiting for the glue to try.

  • Glue in the circular magnets in place

    • You can get away with only placing one circular magnet on the "top" side of the frame.

  • Glue the rectuangular magnets in place.

  • Glue the washers in place.

  • Clip together the logo base and frame parts.

  • Glue the logos to the front side of the slider frame.

  • Use the soldering iron to sink the threaded insert into the underside of the knob.

    • Make sure the threaded insert is nice and flush

  • Place the carriage in the frame and align the knob on the other side. 

  • Place the screw in the carriage and tighten appropriately.

Beyond the Milkometer 3000

You can of course find many different usages for this slider by just reusing the base slider mechansim and placing your own logos on there... 

Tagi