SKÅDIS holder for Wera 395 nutdriver set (thicker shafts)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Hang up your Wera nutdrivers too.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 33
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The Wera 395 Nutsetter kit contains seven nut drivers sized 13, 10, 8, 7, 6, 5.5 and 5mm. Because the shafts are hollow to allow for fastening nuts on long bolts (such as when tightening nuts on long shafts, like on water taps) they are very thick compared to the regular Wera drivers.
There are three STLs provided. For the 395 kit of seven drivers, two of the largest, two of the middle and three of the smaller sizes are required. As with the original model the STEP file is provided in case you want to change it further.
There's one variant - SKADIS_WERA_395_sizes_13_10_SKINNY - this has the sides shaved to arrive at a width of 39mm, so it fits side-by-side in a row with no wasted positions or staggering (pictures are shown of the row of drivers using both versions). You can use this to get the most out of your SKÅDIS area or you can print the wider one that has a uniform side margin with the others.