GPU Anti-Sag Support Bracket - Corsair 4500X-RS
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Tired of heavy graphics cards sagging over time? I designed this custom anti-sag support bracket specifically for my Cor
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 24
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Public Domain
Compatibility:
Case: Corsair 4500X-RS (fits perfectly on the PSU shroud / perforated area).
Designed to support standard modern GPUs.
Hardware Required (Bill of Materials):
1x M5 x 20mm screw
1x M5 washer
1x M5 nut
Print Details (Sliced in OrcaSlicer):
Printer: Creality Ender 3 V3 SE
Filament: Sunlu PETG-CF (Highly recommended for PC parts due to its heat resistance and strength).
Main Slicer Settings:
Layer Height: 0.2 mm (First layer: 0.2 mm)
Walls/Perimeters: 2 (Feel free to increase to 3 or 4 for a heavier GPU).
Infill: 15% (Grid/Crosshatch pattern).
Supports: Enabled - Tree (auto). Note: Tree supports are highly recommended and work perfectly to support the overhangs and the internal nut receptacle.
Speeds: Outer wall 60 mm/s, Infill 180 mm/s, Travel 150 mm/s.
Acceleration: Normal printing 2500 mm/s².
(Note: Settings not listed here are specific to my machine calibration. Standard slicer defaults for the rest of the parameters will work fine).
Installation:
Print the bracket using PETG-CF and remove the tree supports carefully.
Insert the M5 screws through the printed bracket and the existing holes in your case.
Important Note: There is a small built-in receptacle/slot on the back of the original case support (located between the case sheet metal and the printed part) specifically designed to hold the M5 nut in place. This makes installation incredibly easy, as the nut is secured and won't spin while you tighten the screw from the front.
Secure them using the M5 washers and nuts on the back side.
Adjust the height so the top of the bracket gently supports the bottom edge of your GPU.
Optional: The rubber/foam pad on the top of the bracket in the photos is optional. You can use a small piece of double-sided tape or adhesive foam to prevent any scratching and dampen vibrations.
