A simple file to make a cover for the magnetic base of a Matco Light
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This replaces the little rubber cover of a Matco articulated light that wears out of falls off.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 4
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
I made this little piece to replace the rubber cover of a Matco light I have. Under the rubber are exposed magnets that could scratch delicate surfaces or paint. I could not find a sheet of rubber thin enough, so I made my own. It is thin enough to not interfere with the performance of the magnets and fits perfectly in the slot. I used doublestick tape to hold it down but a glue stick should work too. I wouldn't use anything stronger than that so it can easily be removed/replaced if worn or broken. Also remember to trim/smooth any sharp edges