1 / 3
A simple file to make a cover for the magnetic base of a Matco Light — image 1
1 / 3

A simple file to make a cover for the magnetic base of a Matco Light

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

This replaces the little rubber cover of a Matco articulated light that wears out of falls off.

Rating
0 / 5
Likes
0
Downloads
0
Makes
0
Views
4
Reviews
0

Updated at source:

Model information

Category
Other Ideas
License
Creative Commons — Attribution

I made this little piece to replace the rubber cover of a Matco light I have.  Under the rubber are exposed magnets that could scratch delicate surfaces or paint.   I could not find a sheet of rubber thin enough, so I made my own.  It is thin enough to not interfere with the performance of the magnets and fits perfectly in the slot.  I used doublestick tape to hold it down but a glue stick should work too.  I wouldn't use anything stronger than that so it can easily be removed/replaced if worn or broken.  Also remember to trim/smooth any sharp edges