Noble NB4+ Brake Trigger - Varying Thicknesses
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement brake trigger with varying thicknesses for different fitments
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 8
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is an adjusted version of the original NB4+ brake trigger model by jrsone. Developed multiple thicknesses so users can adjust gap feel between the throttle and brake. The base model is very similar to the original small size. 2mm thicker is a good snug fit if you have smaller fingers. You can fine tune the fit to your liking if you by adding some tape around the trigger.
You may need to ream the screw hole out slightly as its a tight fit. Also make sure the screw counterbore is supported, and that you clean out any drooping material so that the screw sits flush after install. This is compatible with the stock trigger screw.
I recommend using a PETG or ABS/ASA. You want to print this fairly solid so that it has a good strength.