Drawer Front Spacer Clip – 3 mm Gap for 18 & 19 mm Boards
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Push-on clips for even 3 mm gaps between kitchen drawer fronts. Versions for 18 mm and 19 mm boards.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 22
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
Simple push-on spacer clips for installing kitchen drawer fronts with a perfectly even 3 mm gap.
HOW TO USE
1. Push a clip onto each top corner of the lower drawer front – the closed end wall stops against the side edge, so every clip sits exactly at the corner.
2. Rest the next drawer front on top of the clips. The 3 mm shelf sets the gap.
3. Fix the front (screws / adjusters), then pull the clips off and reuse them.
VERSIONS
- 18 mm – for 18 mm boards (slot 18.3 mm)
- 19 mm – for 19 mm boards (slot 19.3 mm)
FEATURES
- Exact 3 mm gap shelf
- Closed end wall = corner stop
- +0.3 mm slot clearance so the clip slides off easily after fixing the front
- Lead-in chamfers on the slot openings
- Grip grooves and engraved size on both sides
- 4 mm hole to keep a set together on a string or keyring
PRINT SETTINGS
- Material: PLA
- Layer height: 0.16–0.2 mm
- Walls: 4 (or 100% infill for the strongest clip)
- Supports: none – print as exported, closed wall flat on the bed
- Brim: not needed
- Elephant foot compensation: 0.15 mm recommended for accurate slots
- Print at least 4 clips (one per corner)
- Print time: about 25–35 min per clip
FIT TIP
Real "18 mm" boards are often 18.2–18.5 mm. If the clip is too tight on your boards, scale the model 101–102% in X only, or use the 19 mm version on thick 18 mm boards.
