Creality CR-6 daughterboard mount for HeroMe7 single 5015-part cooling fan
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Creality CR-6 daughterboard mount for HeroMe7 single 5015-part cooling fan
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 4
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I used the original model, and everything fit great, but I found the pressure sensor was not consistent enough to give to a friend. Additionally, I had a spare CR-touch and Microswiss Ender hotend. I went with the HeroMe mounting system.
Design:
-I took the original model and rotated it so the ribbon would then be 90 degrees to the x axis. It was then raised about 24mm to make clearance to access screws for the 5015 fan mounts on the HeroMe.
-combined the above changes with the CR6SE HeroMe Special 1 Gantry v2 from HeroMe respostitory here on Printables.
Hardware:
2 x M3x5x4 heatset inserts as per original model
3x M3 6-8mm to mount to x carriage
Notes:
-There wasn't enough room for the dual 4010 fans, otherwise there would be loss in X. From the HeroMe 5015 fans the HMG7.4-Single-5015-Centered V2.stl part was used. The HMG7.4-Single-5015- ADXL345 Centered Dual Duct.stl probably could be used instead.
-I reduced my build height to 200mm as I went direct drive and didn't want to risk damaging the bowden tube or motor wires
-I went with the following to move the ribbon along x axis instead of through:
https://www.thingiverse.com/thing:4654645
**I'll supply better pictures on the next service.