1 / 6
Creality CR-6 daughterboard mount for HeroMe7 single 5015-part cooling fan — image 1
1 / 6

Creality CR-6 daughterboard mount for HeroMe7 single 5015-part cooling fan

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Creality CR-6 daughterboard mount for HeroMe7 single 5015-part cooling fan

Rating
0 / 5
Likes
0
Downloads
1
Makes
0
Views
7
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

I used the original model, and everything fit great, but I found the pressure sensor was not consistent enough to give to a friend.  Additionally, I had a spare CR-touch and Microswiss Ender hotend.  I went with the HeroMe mounting system.

Design:

-I took the original model and rotated it so the ribbon would then be 90 degrees to the x axis.  It was then raised about 24mm to make clearance to access screws for the 5015 fan mounts on the HeroMe.

-combined the above changes with the CR6SE HeroMe Special 1 Gantry v2 from HeroMe respostitory here on Printables.

Hardware:

2 x M3x5x4 heatset inserts as per original model

3x M3 6-8mm to mount to x carriage 

Notes:

-There wasn't enough room for the dual 4010 fans, otherwise there would be loss in X. From the HeroMe 5015 fans the HMG7.4-Single-5015-Centered V2.stl part was used.  The HMG7.4-Single-5015- ADXL345 Centered Dual Duct.stl probably could be used instead.

-I reduced my build height to 200mm as I went direct drive and didn't want to risk damaging the bowden tube or motor wires

-I went with the following to move the ribbon along x axis instead of through:

https://www.thingiverse.com/thing:4654645

**I'll supply better pictures on the next service.

Tags