Minecraft Player magnetic.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Have you always wanted a minifigure of your own Minecraft character? Add some 5*2 magnets to this model, and you CAN!
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 7
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
🛠 Magnetic Custom Minecraft Papercraft Minifigures
Have you always wanted a physical minifigure of your custom Minecraft character? By combining 3D-printed core limbs, 5x2 mm neodymium magnets, and standard Pixel Papercraft printouts, you can bring your skin off the screen and onto your desk!
This design uses 3D-printed internal blocks that fit inside standard Minecraft papercraft skins, giving them structural support, durable weight, and fully dynamic magnetic posability for the head, arms, and legs.
📦 Materials & Accessories Needed
3D Printed Core Set: Head, torso, arms, and legs (printed in standard PLA/PETG).
Magnets: 5x2 mm round neodymium magnets (recessed into joint sockets).
Papercraft Skins: Printed paper skins cut out and wrapped around the 3D-printed cores.
Glue/Adhesive: Double-sided tape, glue stick, Mod Podge, for mounting the paper skin and superglue for securing the magnets.
🔗 Useful Links & Resources
🖌 Online Free Minecraft Skin Editor: PMCSkin3D
📄 Minecraft Papercraft Generator: Pixel Papercraft Generator
🧲 5x2mm Magnets: Buy on Amazon
🖌 Mod Podge Sealer: Buy on Amazon UK
📏 Precise Pixel Dimensions (1 Pixel = 2mm)
Designed strictly following original Minecraft voxel proportions:
Head: 16 x 16 x 16 mm
Torso: 24 x 16 x 8 mm
Arms (Left & Right): 24 x 8 x 8 mm
Legs (Left & Right): 24 x 8 x 8 mm
💡 Pro Tip: Waterproofing & Protecting Your Figures
Papercraft inks can smudge, run, or warp if exposed to moisture or frequent handling. To make your figures durable and water-resistant:
Mod Podge (Recommended): Apply 1–2 thin coats of Mod Podge (Matte finish) over the papercraft skin after wrapping your printed core. It seals the paper, glues the edges flat, and cures into a durable, moisture-resistant protective shell.
Clear Acrylic Spray: Apply 1–2 light coats of Matte Clear Acrylic Spray onto your paper printout before cutting, or over the finished figure.
Laminate: Use thin, clear cold-laminate film stuck over the printout sheet before cutting and assembling.
I would love to see your characters down below! ;)
Thank you, and as always, Stay Blessed!