1 / 5
Pocket can opener that doubles as a phone stand — zdjęcie 1
1 / 5

Pocket can opener that doubles as a phone stand

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Thin lever that lifts the pull tab on cans, a hook that holds a phone upright, and a keyring hole. 100x20x8mm, 9g PLA+

Ocena
0 / 5
Polubienia
0
Pobrania
2
Wydruki
0
Wyświetlenia
12
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Pets
Licencja
Creative Commons — Attribution

Pocket-sized part with three functions and 9 g of PLA+.

Can opener. The wedge-shaped tongue, 1.2 mm at the tip (six 0.2 mm layers), slides under the pull tab of pet food or soda cans and works as a lever. Thinner chips, thicker won't fit under the tab. The hook at the other end catches the lifted tab and pulls it back to finish opening the can.

Phone stand. The 12 mm slot of the hook holds a phone upright: the edge of the phone sits in the slot, the rest of that edge rests on the table, and the 100 mm bar acts as the foot. An iPhone 16 without a case (7.8 mm) leans about 23 degrees from vertical; with a case (11.5 mm) it stands almost straight, at 3 degrees.

Keyring. 3 mm hole in the side strip of the hook. The ring only wraps the 5 mm strip and stays out of the phone's way.

Geometry

- 100 x 20 x 8 mm bar, all edges rounded with 1 mm (minkowski with a sphere) so they don't dig into a pocket or a hand

- Two 11 mm holes and a waist in the middle to cut weight and give grip

- Text engraved top and bottom (Liberation Sans Bold, 5 mm, 0.6 mm deep); remove it or change it in the .scad

Printing

Print flat on the bed as the STL comes, no rotation, no supports. The settings below are the ones used for the part in the photos and are overkill for a 9 g part on purpose: the tongue is used as a real lever and with 4 walls and 30% infill the tip holds.

- Ender-3 V3 KE, PLA+, 0.4 mm nozzle

- 0.2 mm layers, 4 walls, Alternate Extra Wall and Print Thin Walls on

- 30% gyroid infill, 5 top and 5 bottom layers

- 220 C nozzle (225 for the first layer), 60 C bed, fan at 100%

- Hole Horizontal Expansion 0.1 mm so the slot and the keyring hole come out to size

- Skirt, no brim

- Minimum layer time 10 s to protect the thin tip

Notes

- The STL was measured and tuned with calipers. If the phone doesn't fit or wobbles, the slot width is a parameter in the .scad.

- Made for a 3D design and printing course in a computer engineering master's program. It started as a tab lifter for the cat food cans and only later turned out that the hook could hold a phone.

Tagi