IKEA Greek Key & Medusa Decorative Trim / Molding
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A modular decorative Greek Key trim system designed specifically for the 32 mm hole pitch on IKEA PAX wardrobe
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 19
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
System Overview & Parts
Left & Right Side Profiles: Separate files are provided for the left and right sides. The center pin alignment is intentionally offset so that the Greek meander pattern remains visually symmetrical and continuous without cutting into the decorative geometry.
Bottom Profiles: Dedicated bottom segments designed to cleanly terminate at the base of the cabinet frame.
Medallion Accent (Plate 5): Features an integrated rear recess to neatly conceal existing frame assembly screws while sitting flush against the board.
Print Recommendations
Material: PLA, PETG, or PLA Wood
Layer Height: 0.16 – 0.20 mm
Wall Loops: 2–3
Infill: 15% – 20%
Orientation: Print flat on the build plate for standard trim pieces. For the medallions, use a wide outer brim (8–10 mm) and sturdy tree supports if printed at an angle, or print flat with top surface ironing enabled.
Assembly / Workflow Tip:
Pick one side first (left or right) and stick to it!
Start by printing the longest pieces (10-pin segments) to cover the bulk of the height. If needed, you can easily trim the ends with flush cutters or scissors to fine-tune the final length.
Finish off that side using the matching bottom segment based on your remaining hole count.
Once done, move on to the other side.
Fair warning: chaos is guaranteed anyway! :))))