Kit Card Biplane - Snap-Fit Toy Plane, Rolling Wheels, No Supports
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
One flat print, snap out 13 parts and build a classic biplane with rolling wheels. No glue, no supports.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 14
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Vehicles
- Licencja
- Creative Commons — Attribution — NoDerivatives
A classic biplane on a single flat kit card. Print one thin card, snap the 13 parts off the sprue and slot them together into a little vintage biplane with wheels that actually roll. No glue, no supports, no screws.
Why it's fun: it prints fast, it feels like opening an old plastic model kit, and the finished plane sits on its wheels and tail like a real taildragger. Great for kids, desk toys, party favours and quick test prints. Print the card in one colour or swap filament at different layers for a two-tone kit.
Parts on the card (13): fuselage with tail fin, lower wing, upper wing, 2 interplane struts, tailplane, propeller, 2 landing gear legs, 1 square axle, 2 wheels.
Card size: 116.5 x 76 x 2.5 mm. Assembled plane: about 68 mm long, 70 mm wingspan, 33 mm tall.
Assembly
Step 1: Snap all parts off the card and clean the small gate nubs with a hobby knife or a file so the edges are flat.
Step 2: Push the propeller down onto the notch at the top of the nose.
Step 3: Slide the tailplane forward into the horizontal slot at the back of the fuselage.
Step 4: Lift the lower wing up onto the fuselage from underneath. The long slot goes around the fuselage and the rear bridge clicks into the notch on the bottom of the fuselage.
Step 5: Slide the two landing gear legs forward into the inner slots on the back edge of the lower wing, with the round axle holes facing down.
Step 6: Hold the upper wing above the lower wing and slide the two struts forward into the outer slots of both wings at the same time.
Step 7: Press the wheels onto the ends of the square axle, then snap the axle up into the round holes in the gear legs. The axle spins freely, so the plane rolls.
Print settings
PLA (PETG works too), 0.2 mm layer height, 2 to 3 walls, 15 to 20 percent infill, no supports. A brim is optional and only helps if your bed adhesion is weak. Print time is roughly 45 to 60 minutes on most printers. The gates are 1.0 mm thick and 1.2 mm wide so the parts snap out cleanly. Slots are 2.65 mm for 2.5 mm parts; if your printer runs tight, a quick pass with a file makes everything slide together.
If you print one, please post a Make and share a photo of your plane. I would love to see your colour schemes!
