2x DGX Spark - Noctua NF-A20 filtered enclosure
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A 10 part air filtered enclosure with hex grid front and 4 point dgx mount that positions the sparks for optimal airflow
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 286
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
This model is made is 3dsmax and optimized for dual DGX Sparks
The enclosure is optimized for dust proof airflow for the devices. The entire enclosure can be safely printed with PLA, except the DGX mount, where the recommended material is PETG. The whole entire model is tight enough, but due to the assmebly and disassembly it will have a very good fit at the end without distortion, but certain parts still needs a bit of sending. (especially the seams)
About the enclosure and DGX Spark temperatures and the proper filter. I am using simple foam filters with 30-40PPI. Since the enclosure uses a low static pressure fan, higher density is NOT recommended. The enclosure has a carefully designed plenum chamber, that equalizes the air pressure so the fan won't struggle. The entire case is fully open back, so the heat can flow out from the critical parts.
The case front has an NxN size, so the grid can be rotated or even the case can be used in different positions. The sparks are in a standing position. I recommend to remove the bottom lid that covers the WiFi antenna, for better cooling.
Average temps in a 25 C room:
GPU:
idle: 47-48
load: 79-81
CPU:
idle: 49-50
load: 88-92
These are peak values. They almost never exceed these even on heavy load. (SEE ATTACHED IMAGES)
NOTE: The fan attachment has two parts and it's not a single model for both sides. Noctua NF-A20 has a notch on top where the cable goes out. That faces to the blowing side towards the big enclosure. That part has a notch as well, where the cable can be routed.
NOTE2: The DGX mount part. Use both if possible since that gives more stiffness to the entire enclosure.
NOTE3: You need 2 connecting frames, one for the fan enclosure and on e for the ending piece.
NOTE4: The fan grid -> fan spacer needs a little push. It's intentional so it keeps the grid and filter in place appropriately.
Front fan airflow video on the front filter:
https://photos.app.goo.gl/3uWVYEj4bkSXE22e8