Cross Window Frame with Shutters - Multi-Part, No AMS Needed
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Window frame with cross bars and a pair of plank shutters with hinge straps, for a wooden cat house. No supports.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 3
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Pets
- Licencja
- Creative Commons — Attribution — Noncommercial
A window with cross bars and a pair of plank shutters, made for my cat Woody's wooden outdoor house. The frame has a sleeve that goes through the wall and holds a clear acrylic pane.
Every part is a separate single-colour file, so you can print it in several colours without an AMS. Everything prints flat, without supports.
Matching flower box to put under the window: https://www.printables.com/model/1894852
Parts (suggested colours):
Window frame with cross, 166 x 166 mm, 120 x 120 mm glazed area (white)
Pane retainer ring (white)
Left and right shutters, 65 x 166 mm, plank and Z-brace relief (sky blue)
Hinge straps x4 with nail heads (black)
You also need: a 3 mm clear acrylic (plexiglass) pane, cut to 129 x 129 mm.
Installation:
Cut a 137 x 137 mm square hole in the wall. The sleeve is designed for a 27.2 mm wall (wood + insulation).
Screw the frame from the outside (8 countersunk holes for 4 mm wood screws).
From the inside, slide the acrylic pane into the sleeve until it rests against the cross.
Push the retainer ring in behind the pane. It ends flush with the sleeve; a dot of glue holds it.
Glue each hinge strap into the pocket on the shutter rails, round end towards the outside.
Glue the shutters on the wall right against the frame, one on each side.
Print settings: PLA or PETG, 0.2 mm layers, 15-20 % infill. Print the frame visible face down on the bed.