1 / 7
silent 3 bladed prop -  I got the equation curves down in inventor. — zdjęcie 1
1 / 7

silent 3 bladed prop - I got the equation curves down in inventor.

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Uppdate 29.11.15 Added 9X4.5 blade sett, (Prop4) i hadent done this for a while so i hope i got it right. I finally…

Ocena
0 / 5
Polubienia
4
Pobrania
72
Wydruki
0
Wyświetlenia
325
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Share Alike

Uppdate 29.11.15

Added 9X4.5 blade sett, (Prop4) i hadent done this for a while so i hope i got it right.

I finally got the equation curves in inventor all set, if somone wants a spesific airfoil profile let me know.

This has less tip turbulence and makes a lot less noice

I use it as a silent replacement for 5-7" props for my quad.

3 mm axel

print as solid.

I print it on hight resolution and treat it with acetone vapour

I have upploaded an inventor file with a naca profile equation curve, feel free to make any wing profile by simply tweeking the numbers.

Instructions

Equation curve in inventor.

thickchordt5(0.2969sqrt((1 in)/chord)-(0.1260t1 in)/chord-(0.3516t^31 in^2)/(chord^2 )+(0.2843t^51 in^3)/(chord^3 )-(0.1015t^7*1 in^4)/(chord^4 ))

where:

• c is the chord length,

• x is the position along the chord from 0 to c,

• y is the half thickness at a given value of x (centerline to surface), and

• t is the maximum thickness as a fraction of the chord (so 100 t gives the last two digits in the NACA 4-digit denomination).

You need to add chord and thick as variables in inventor (the fx button) before compiling the equation curve,

PS ! The part file mustbe in inches!!!!!!

The foil must be made in 2 sections one for the top curve and one for the lower just add "-" in front of the lover airfoil curve.

Category: R/C Vehicles

Tagi