Led Zeppelin Custom Geometric Display Plaque
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Good Times Bad Times! Print this original geometric Led Zeppelin custom stacked logo plaque complete with alignment jig.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 5
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Kashmir vibes for your studio wall! This 3D wall display plaque captures a custom, angular stacked geometric rendition of the Led Zeppelin name—incorporating a dynamic connection between the upper "LED" block and the lower "ZEPPELIN" bar.
This model is a original custom layout adapted directly from my hand-drawn 90s pen-and-ink series, bringing a fresh, stylized aesthetic to classic rock display art!
This model is part of my Slave To The Metal 90s Drawing Series /Collection, where I am systematically turning my original hand-drawn concept art of classic band logos into clean, printable display pieces.
Border Profile & Custom Alignment Jig:
Border Only Option: Designed with a clean, form-fitting outer backing border plate to support the interconnected geometric letterforms.
Included Printable Alignment Jig: Because the mounting keyholes are offset at an angle due to the staggered text geometry, a custom printable alignment jig is included so you can easily mark your wall fastener holes perfectly level every time!
Easy Multi-Color Printing:
With a 0.125” base border plate and raised 0.375” lettering (0.5” total thickness), executing a simple manual z-height filament swap in your slicer lets you pop the bold red geometric letters off a crisp white or black backing without needing multi-material hardware (AMS/MMU).
Dimensions
Text Width: 8”
Text Height: 2.7”
Text Thickness: 0.375”
Border Width: 8.25”
Border Height: 2.95”
Border Thickness: 0.125”
Total Thickness: 0.5”
Mounting: Features (2) built-in keyhole slots on the back designed for #3 screws for a completely flush wall mount.
Print Settings
Material: PLA
Layer Height: 0.12mm to 0.20mm (Lower layer heights yield exceptionally smooth top surfaces across the bold geometric angles).
Infill: 10% or higher (Gyroid or Grid patterns work great).
Supports: None required when printed flat on the bed.
Looking for the traditional art-deco font or Swan Song Icarus models?
Check out my companion listing here:
Where It All Began:
Curious about the original hand-drawn concept art that inspired this whole series? Check out the model that started it all: