Led Zeppelin Custom Geometric Display Plaque
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Good Times Bad Times! Print this original geometric Led Zeppelin custom stacked logo plaque complete with alignment jig.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 2
- Makes
- 0
- Views
- 5
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Home Decor
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Kashmir vibes for your studio wall! This 3D wall display plaque captures a custom, angular stacked geometric rendition of the Led Zeppelin name—incorporating a dynamic connection between the upper "LED" block and the lower "ZEPPELIN" bar.
This model is a original custom layout adapted directly from my hand-drawn 90s pen-and-ink series, bringing a fresh, stylized aesthetic to classic rock display art!
This model is part of my Slave To The Metal 90s Drawing Series /Collection, where I am systematically turning my original hand-drawn concept art of classic band logos into clean, printable display pieces.
Border Profile & Custom Alignment Jig:
Border Only Option: Designed with a clean, form-fitting outer backing border plate to support the interconnected geometric letterforms.
Included Printable Alignment Jig: Because the mounting keyholes are offset at an angle due to the staggered text geometry, a custom printable alignment jig is included so you can easily mark your wall fastener holes perfectly level every time!
Easy Multi-Color Printing:
With a 0.125” base border plate and raised 0.375” lettering (0.5” total thickness), executing a simple manual z-height filament swap in your slicer lets you pop the bold red geometric letters off a crisp white or black backing without needing multi-material hardware (AMS/MMU).
Dimensions
Text Width: 8”
Text Height: 2.7”
Text Thickness: 0.375”
Border Width: 8.25”
Border Height: 2.95”
Border Thickness: 0.125”
Total Thickness: 0.5”
Mounting: Features (2) built-in keyhole slots on the back designed for #3 screws for a completely flush wall mount.
Print Settings
Material: PLA
Layer Height: 0.12mm to 0.20mm (Lower layer heights yield exceptionally smooth top surfaces across the bold geometric angles).
Infill: 10% or higher (Gyroid or Grid patterns work great).
Supports: None required when printed flat on the bed.
Looking for the traditional art-deco font or Swan Song Icarus models?
Check out my companion listing here:
Where It All Began:
Curious about the original hand-drawn concept art that inspired this whole series? Check out the model that started it all: