1 / 3
Rack-Mount Chalk Block Tray (5/8" holes) + Drop-in Grate, No Supports — zdjęcie 1
1 / 3

Rack-Mount Chalk Block Tray (5/8" holes) + Drop-in Grate, No Supports

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Chalk tray that plugs into a 5/8 inch power-rack hole, with a drop-in crumble grate. Prints with no supports.

Ocena
0 / 5
Polubienia
0
Pobrania
0
Wydruki
0
Wyświetlenia
5
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Indoor Sports
Licencja
Creative Commons — Attribution — Noncommercial

Open chalk tray that plugs straight into a power-rack upright hole, so your chalk block sits at hand height instead of on the floor. The pocket fits a standard 2 oz block (89 x 89 x 44 mm). A slotted drop-in grate sits above a 10 mm sump, so loose chalk falls below and the block stays dry. Lift it out by the finger notches and tip out the dust.

Fits 5/8 inch (15.9 mm) holes on 3x3 inch uprights. The CadQuery source is included, so you can change the pin size, upright width and pocket.

Print settings: PETG, 0.2 mm layers, 4 walls, 25-30% gyroid infill, no supports. The body prints upright as exported, and the grate prints flat. Size 105 x 152 x 63 mm, about 106 g in total. Two colours as two parts: no AMS needed.

Designed by M2Labs with AI-assisted modelling. The images are 3D renders, and the print has not been tested yet, so please share your make and any fit notes.

Tagi