Rack-Mount Chalk Block Tray (5/8" holes) + Drop-in Grate, No Supports
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Chalk tray that plugs into a 5/8 inch power-rack hole, with a drop-in crumble grate. Prints with no supports.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 0
- Makes
- 0
- Views
- 5
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Indoor Sports
- License
- Creative Commons — Attribution — Noncommercial
Open chalk tray that plugs straight into a power-rack upright hole, so your chalk block sits at hand height instead of on the floor. The pocket fits a standard 2 oz block (89 x 89 x 44 mm). A slotted drop-in grate sits above a 10 mm sump, so loose chalk falls below and the block stays dry. Lift it out by the finger notches and tip out the dust.
Fits 5/8 inch (15.9 mm) holes on 3x3 inch uprights. The CadQuery source is included, so you can change the pin size, upright width and pocket.
Print settings: PETG, 0.2 mm layers, 4 walls, 25-30% gyroid infill, no supports. The body prints upright as exported, and the grate prints flat. Size 105 x 152 x 63 mm, about 106 g in total. Two colours as two parts: no AMS needed.
Designed by M2Labs with AI-assisted modelling. The images are 3D renders, and the print has not been tested yet, so please share your make and any fit notes.
