1 / 7
TPA3116 subwoofer amplifier (built-in power supply) — zdjęcie 1
1 / 7

TPA3116 subwoofer amplifier (built-in power supply)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Simple housing for a TMA3116 mono subwoofer board and a repurposed Thinkpad adapter, with a faux wooden texture

Ocena
0 / 5
Polubienia
0
Pobrania
1
Wydruki
0
Wyświetlenia
19
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Audio
Licencja
Creative Commons — Attribution — Share Alike

I got my hands on an old passive amplifier, not good enough to warrant buying a >100€ amp, but not bad enough to throw away.

I found a TMA3116 mono subwoofer board online for cheap (~10€) which I could power with one of the many old Thinkpad adapters I had laying around, and decided to create a case for it.

The volume/crossover knobs are hidden by default by design; I didn't want anyone to fiddle with them once I set it up, especially since the 65W charger and the 100W-capable board could easily blow it, and also because I did not want anything to stick out the front or the back if not necessary

Bill of materials

  • TMA3116 mono subwoofer amplifier (I used this one)

    • Board dimensions: 83 × 55 mm

    • Screw dimensions 65 × 49 mm

  • Lenovo Thinkpad 65W charger

  • Zip tie for the charger, max 5 mm width

  • Whatever screw fits

  • Right-angled jack audio cable if needed

Printing

Base

I tried creating a wooden texture using BumpMesh but I am not thrilled with the results. I used wood3 as wood1 seemed to on-the-nose, but perhaps I should've used the latter as it's not really recognizable as wood. I included both the clean and the textured models.

  • PLA is enough

  • Organic supports on build plate help with bridging

    • Only necessary for the holes, you might need to tweak the permissible angle if using the textured version

  • Scarf joints help hide the perimeters; check where they are if you don't use them as they don't look nice on this model

Printed on MK4S / Prusament rPLA Wine Pigment

Cover

I wanted it to be friction-fit but it's quite loose. If you want it like that, you might need to enlarge it. I used double-sided tape as it would be a waste to print it again.

  • PETG, especially if you need more power, to avoid deformations due to heat

  • No top/bottom layers

  • 30% honeycomb infill

  • Satin base plate highly recommended if you want the finish like in the photos

Printed on MK4S / Prusament PETG Matte Black

Customisation

(I'll upload the Fusion model soon)

The model is parametric, to a degree. You should be able to use a different-sized Thinkpad adapter simply enough or a different amp board, though you might need to tweak the spacing slightly to accommodate a different layout.

Tagi