1 / 3
Filament Roller for YOOPAI dry boxes — zdjęcie 1
1 / 3

Filament Roller for YOOPAI dry boxes

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Filament roller to fit the new YOOPAI Pro filament storage boxes found on Amazon.

Ocena
0 / 5
Polubienia
3
Pobrania
15
Wydruki
0
Wyświetlenia
65
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution

Filament roller to fit the new YOOPAI Pro filament storage boxes found on Amazon.  I really like these new boxes over the previous "cereal box" design that have become du jour for filament storage of late.  These are smaller and stack much better than the cereal boxes I've used previously.

This filament roller is designed to fit in the lid with the box placed upside down over it. 

Recommended settings:

  • You may want to print the Roller and Axle with 3 walls (or more?  Though I've initially printed my first set of four units with 2 walls as I totally forgot about it for my prints...  LOL)

  • Designed for PETG tolerances.  I wouldn't recommend PLA as it will deform over time while supporting weight.  You might be fine with the Roller Body base itself, but I certainly wouldn't trust the Rollers or Axles in PLA for anything mid- to long-term.

  • The Axles at stock size will require smoothing down the "elephant foot" on the bottom face as well as shaving down any corner inconsistencies at the hexagonal end you'll be inserting through the Roller in order to allow the Axle to actually slide all the way through without getting stuck. 

    • To avoid, or at least limit this extra step, I recommend printing the Axles at 99% or 98% and test before committing to printing out a bunch of them.  This won't affect the length enough to be any issue, so test until you find the fit that'll work for you.

    • The Axles were designed to be a friction fit, but while holding the weight of a spool, they probably don't need to be all that tight a fit through the Rollers.  \_(ツ)_/

  • Designed to use standard 608 bearings like these ones.  The bearings fit snugly into their mount locations on my prints of the Roller Body.

To do: 

  • I don't have a desiccant storage setup yet.  For the moment, I've just been using packets of desiccant, or as seen in a photo above, just pouring desiccant within the cutouts of the Roller Body base.

Tagi