1 / 4
Kit Card Helicopter - Snap-Fit Toy, Spinning Rotors, No Supports — zdjęcie 1
1 / 4

Kit Card Helicopter - Snap-Fit Toy, Spinning Rotors, No Supports

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

One flat print: snap out 10 parts and build a helicopter with spinning main and tail rotors. No glue, no supports.

Ocena
0 / 5
Polubienia
0
Pobrania
10
Wydruki
0
Wyświetlenia
14
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Vehicles
Licencja
Creative Commons — Attribution — NoDerivatives

A complete helicopter on a single flat card. Print it in one go, snap the 10 parts off the frame, slot them together and you have a little utility helicopter whose main rotor and tail rotor really spin. No glue, no supports, no screws.

Why it's fun: it prints fast, it looks like a real model kit when it comes off the printer, and kids (and adults) love building it and flicking the rotors round. Great as a party favour, a desk toy or a quick gift print.

Parts on the card: fuselage with tail fin and rotor mast, front cabin frame with landing legs, rear cabin frame with landing legs, two landing skids, tail stabilizer, main rotor, rotor cap, tail rotor and tail rotor axle.

Card size: 131 x 83 mm, 2.5 mm thick. Assembled helicopter: about 84 mm long, 82 mm rotor span, 46 mm tall.

Assembly

Step 1: Twist the parts off the card and trim any gate nubs with a knife, file or flush cutters.

Step 2: Slide the two cabin frames onto the fuselage: the slots in the frames go over the slots in the fuselage belly. The taller frame goes at the back, under the rotor mast.

Step 3: Press the two skids onto the feet of the cabin frames (the notches lock together).

Step 4: Slot the tail stabilizer onto the underside of the tail boom.

Step 5: Drop the main rotor over the square mast on top of the fuselage, then press the red rotor cap onto the mast to hold it. Leave a tiny gap so the rotor spins freely.

Step 6: Push the tail axle through the round hole in the tail fin and press the tail rotor onto its end. Give both rotors a flick.

Print settings

PLA (PETG also works), 0.2 mm layers, 2 to 3 walls, 15 to 20% infill. No supports needed and it prints flat on the bed; a brim is optional if your bed adhesion is poor. Takes roughly 30 to 40 minutes on a typical printer. Slots are 2.65 mm wide for 2.5 mm parts; if your printer runs tight, lightly sand the slots or scale X/Y to 101%.

Tip: print it in two colours with a filament change, or paint the rotors after assembly.

If you build one, please post a Make with a photo, I would love to see your helicopters! Check out my other kit cards too: F1 race car, monster truck, biplane and more.

Tagi