Hinged Pumpkin Candy Bowl | Trick-or-Treat Jar
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Ribbed pumpkin candy jar with a hinged lid.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 18
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Autumn & Halloween
- Licencja
- Creative Commons — Attribution
A ribbed pumpkin candy bowl for trick-or-treaters, with a lid that stays attached to the pumpkin by a real hinge. Flip it open, grab a sweet, flip it closed.
Designed for single-color printing: one spool of orange PLA, no AMS or multicolor needed.
FEATURES
8-rib pumpkin shape with a squat, classic silhouette
Hinged lid (opens past 90°), so it can't get lost or dropped
Stem doubles as a handle for opening the lid
Flat base, stands securely
~90 mm wide opening, easy for small hands to reach in
Lightweight: thin 1.8 mm walls, about 85 g of filament in total
SIZE
Small fits any common print bed
PRINTING
Two parts: body and lid. Print each one in the orientation it sits on the table (both flat bottom, nothing to rotate)
Material: PLA
Layer height: 0.24 mm
Walls: 2 (the body is basically all walls)
Infill: 9% (only matters for the lid)
Supports: lid none. Body: the curve right above the flat bottom is a slightly steep overhang. Most printers handle it with good cooling. If yours sags there, use tree supports touching the build plate only.
ASSEMBLY (HINGE PIN)
The hinge pin is a piece of your 1.75 mm filament:
Put the lid on the body and line up the three hinge knuckles at the back
Push a ~38 mm piece of 1.75 mm filament through the 2.2 mm hole
(optional) Slightly melt or squash both ends (lighter, soldering iron, or a hot nozzle) so the pin can't slide out
Done! Fill with candy and put it on the doorstep.