1 / 3
Annoying gift tube — zdjęcie 1
1 / 3

Annoying gift tube

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Gift box with annoying opening mechanism

Ocena
0 / 5
Polubienia
2
Pobrania
0
Wydruki
0
Wyświetlenia
42
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Really annoying gift box that fits iPhone box(inner diameter 101mm, 181mm height). You have to synchronize two worm screws to rotate the lid along a regular thread. It takes roughly 5 minutes to open. Worth every second of print time.

Fits 180x180mm beds

Tools needed

  • 8.7mm drill bit

Hardware needed

  • M5x10-20mm SHCS - 4pcs

Recommended print parameters

  • Minimum filament: PLA

  • Recommended filament: PETG

  • First layer height: 0.2mm

  • Layer height: 0.2mm - worm gears can benefit from printing at 0.12mm LH

  • Perimeters: 2-3

  • Bottom/top layers: 4-5

  • Infill: 10%

  • Brim: no

  • Supports: no

Assembly

  • Carefully drill out the 4 bolt-head holes to 8.7 mm using a drill bit. Do this by hand to avoid damaging the printed parts.

  • Insert the worm gear

  • Screw M5 bolts into worm gear through bottom piece

  • Glue blank pieces to screw heads with superglue - this is optional

  • Insert your gift into the box

  • Screw the lid on with 2 worm gears

OR

  • Carefully drill out the 4 bolt-head holes to 8.7 mm using a drill bit. Do this by hand to avoid damaging the printed parts.

  • Insert the gift into the box

  • Screw the lid on

  • Insert the worm gears

  • Screw M5 bolts into the worm gear through bottom piece

  • Glue blank pieces to screw heads with superglue - this is optional

Tagi