1 / 2
Coraline "Other Father" eyes — zdjęcie 1
1 / 2

Coraline "Other Father" eyes

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

In the Movie "Coraline", her "Other Father" has button eyes sewn on. These hurt less.

Ocena
0 / 5
Polubienia
1
Pobrania
1
Wydruki
0
Wyświetlenia
38
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

In the Movie "Coraline", her "Other Father" has button eyes sewn on. These hurt less, as they're held up by his readers.

The buttons

  • See through hack - use a model height range modifier for the flat part, with zero top and bottom layers, honeycomb infill at 50%.

  • Stitch some needlepoint thread through the holes in an "X" shape, secure it with CA glue, and trim thread flush on the back with a razor blade. Unlike me, use different colors for button and thread so thread is more visible. You could also use small lengths of filament instead of thread.

The glasses

  • Three pieces and printed from PETG for toughness - the frame and two bows.

  • Frame - printed with top of bridge flat on plate, with support.

  • You can probably scale and/or hot bend these to fit. Or tweak a copy of the model

  • Bows:

    • hot bend front of bow at nearly right angle. The front should be flat and just long enough to glue to frame.

    • After you get them the right shape, glue them to the frame.

    • clip the bows to length

    • hot bend rear of bow to fit ear

    • hot bend rest of bow as needed to fit your head

Assembly

  • Figure out where to put buttons - cosmetically, you want them positioned to you eye sockets. Practically, you want them positioned so the thread isn't centered on your eye.
    Realistically, the view is fine, but gets annoying after a while. It's a compromise.

  • For gluing, I taped the glasses to a small block of wood for stability.

  • A quick spray of CA activator after assembly will help glue firm up. 

Hot bending - not so scary - Thin PETG pieces can be hot bent by dipping in boiling hot water for a few seconds until pliable. You only get a few seconds before it solidifies, but you can retry as needed.

Glue - I used Loctite's "Plastics Bonding System" which has a surface activator pen + cyanoacrylate gel glue. ("Full cure" is said to be 24 hours - I was in a hurry, so I hit it with a spray of CA accelerator after assembly. You do you.) That glue was amazing - I'd printed the buttons in ABS in case I wanted to vapor smooth them, and an ABS/PETG bond would normally be dodgy with other glues. I torture tested a prototype, and the plastic ripped instead of the joint failing.

Tagi