Coraline "Other Father" eyes
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
In the Movie "Coraline", her "Other Father" has button eyes sewn on. These hurt less.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 1
- Makes
- 0
- Views
- 38
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Costume Accessories
- License
- Creative Commons — Attribution
In the Movie "Coraline", her "Other Father" has button eyes sewn on. These hurt less, as they're held up by his readers.
The buttons
See through hack - use a model height range modifier for the flat part, with zero top and bottom layers, honeycomb infill at 50%.
Stitch some needlepoint thread through the holes in an "X" shape, secure it with CA glue, and trim thread flush on the back with a razor blade. Unlike me, use different colors for button and thread so thread is more visible. You could also use small lengths of filament instead of thread.
The glasses
Three pieces and printed from PETG for toughness - the frame and two bows.
Frame - printed with top of bridge flat on plate, with support.
You can probably scale and/or hot bend these to fit. Or tweak a copy of the model
Bows:
hot bend front of bow at nearly right angle. The front should be flat and just long enough to glue to frame.
After you get them the right shape, glue them to the frame.
clip the bows to length
hot bend rear of bow to fit ear
hot bend rest of bow as needed to fit your head
Assembly
Figure out where to put buttons - cosmetically, you want them positioned to you eye sockets. Practically, you want them positioned so the thread isn't centered on your eye.
Realistically, the view is fine, but gets annoying after a while. It's a compromise.For gluing, I taped the glasses to a small block of wood for stability.
A quick spray of CA activator after assembly will help glue firm up.
Hot bending - not so scary - Thin PETG pieces can be hot bent by dipping in boiling hot water for a few seconds until pliable. You only get a few seconds before it solidifies, but you can retry as needed.
Glue - I used Loctite's "Plastics Bonding System" which has a surface activator pen + cyanoacrylate gel glue. ("Full cure" is said to be 24 hours - I was in a hurry, so I hit it with a spray of CA accelerator after assembly. You do you.) That glue was amazing - I'd printed the buttons in ABS in case I wanted to vapor smooth them, and an ABS/PETG bond would normally be dodgy with other glues. I torture tested a prototype, and the plastic ripped instead of the joint failing.
