1 / 2
PCO 1881 and PCO 1810 Bottle Neck Go No-Go Gauge (28 mm PET) - Concept, not print-tested — zdjęcie 1
1 / 2

PCO 1881 and PCO 1810 Bottle Neck Go No-Go Gauge (28 mm PET) - Concept, not print-tested

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Flat go/no-go pocket gauge for 28 mm PET bottle necks (PCO 1881/1810). Concept, not print-tested.

Ocena
0 / 5
Polubienia
0
Pobrania
1
Wydruki
0
Wyświetlenia
1
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution

A flat pocket gauge for quick checks of 28 mm PET bottle necks (PCO 1881 and the older, taller PCO 1810 finish).

  • GO hole (27.75 mm): a good thread outer diameter (T) should pass.

  • NO GO hole (27.15 mm): a good thread should NOT pass (undersize check).

  • RING hole (33.6 mm): the support ring should pass with little play.

  • Two labelled height steps, 17 mm (PCO 1881) and 21 mm (PCO 1810): compare against the neck height from top to support ring.

Reference dimensions from public sources:

  • PCO 1881: thread T 27.40 mm (plus or minus 0.13), support ring 33.0 mm, height 17.00 mm, pitch 2.7 mm.

  • PCO 1810: thread T 27.43 mm (plus or minus 0.13), support ring 33.00 mm (plus 0.38), height 21.00 mm, pitch 3.18 mm.

Sources: Alcoa PCO 1810 neck finish specification drawing (1998 revision); Multi Design Packaging neck finish glossary (GME 32.03 and GME 32.04); Gotmar PCO preform and closure datasheet; XEM Studio PET bottle neck reference sheet. The ISBT PCO 1881 master drawing itself was not accessible.

Hole sizes include print clearance. Status: CONCEPT, NOT PRINT-TESTED. Printers vary, so verify printed holes with a caliper before use. Not a certified measuring tool.

Designed by Anton Klitin, CAD engineer (CadQuery, FreeCAD). Open to freelance CAD work.

Tagi