Fan Shroud for Noctua 40x10 on Inspur LSI 9300 8i
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Fan shroud fitting a Noctua 40x10 and any 50x50x11 heat sink, like on a Inspur LSI 9300 8i
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 30
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A fan shroud that will fit a 50x50x11 (mm) heat sink, like on an Inspur LSI 9300 8i.
You'll need a Noctua 40x10 fan, although any other 40x10 might fit, just make sure the cables are on the right side. I've added the source file in Fusion, so you may do any adjustments if needed.
Printing requires a tiny bit of support on the clips, but that's easy to remove.
Disclaimer
The Fusion file contains/links to the official CAD of the Noctua Fan. They hold all rights on that CAD, so whatever license they specify for that CAD will apply to it, irrespective of what the rest of this design is licensed under.
https://www.noctua.at/en/3d-cad-models
https://www.noctua.at/en/products/nf-a4x10-pwm/downloads
This was designed with a personal license of Fusion, so no commercial use, sadly.