Fan Shroud for Noctua 40x10 on Inspur LSI 9300 8i
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€0.62 – €0.75 net (excluding VAT)
For file: inspur_9300_i8_hba_fan_shroud_noctua_10mm_mirrored_0.4n_0.2mm_PETG_MK4IS_39m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.69 excluding VAT (range midpoint).
- Weight reported by the author
- 10 g
- Print time reported by the author
- 39 min
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Fan shroud fitting a Noctua 40x10 and any 50x50x11 heat sink, like on a Inspur LSI 9300 8i
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 12
- Makes
- 0
- Views
- 47
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A fan shroud that will fit a 50x50x11 (mm) heat sink, like on an Inspur LSI 9300 8i.
You'll need a Noctua 40x10 fan, although any other 40x10 might fit, just make sure the cables are on the right side. I've added the source file in Fusion, so you may do any adjustments if needed.
Printing requires a tiny bit of support on the clips, but that's easy to remove.
Disclaimer
The Fusion file contains/links to the official CAD of the Noctua Fan. They hold all rights on that CAD, so whatever license they specify for that CAD will apply to it, irrespective of what the rest of this design is licensed under.
https://www.noctua.at/en/3d-cad-models
https://www.noctua.at/en/products/nf-a4x10-pwm/downloads
This was designed with a personal license of Fusion, so no commercial use, sadly.