ForgeStack Pen Cup Module 1×1 — Modular Desk Organizer, Support-Free
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A 100 mm pen cup on the ForgeStack 40 mm grid — drops onto any baseplate cell or stands alone. Support-free.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 2
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial
A tall pen cup that belongs to a system: the 1×1 ForgeStack cup (40 × 40 mm footprint, 100 mm tall) drops onto any single cell of a ForgeStack baseplate and stays put — or stands alone on the desk. Pens, pencils, brushes, screwdrivers, craft tools.
**Print details**
- Designed for support-free FDM printing. Slicer-validated (OrcaSlicer, 0.4 nozzle, 0.2 layer, PLA) — community printing in progress: be one of the first to print it and share your make!
- One cell of the system: 40 × 40 mm footprint (41.2 mm deep overall including the label frame), 100 mm tall, 34 mm square interior
- Underside socket (12 × 12 mm) drops onto any baseplate pin — 0.5 mm clearance, no press-fit
- Raised label frame on the front for a 30 × 24 mm paper label
- Thick 3 mm walls and a weighted plug base — it does not tip like a bare cup
- The ForgeStack system: every module is built on a 40 mm grid. Baseplates carry square locating pins (11 × 11 mm, 4 mm tall) at the cell centres; every bin underside has matching square sockets (12 × 12 mm, 4.5 mm deep) — a drop-in fit with 0.5 mm clearance per side, no press-fit, no hardware.
- Bins also stack: the tapered plug on the underside (51° flare, so it prints clean) drops into the open mouth of the bin below with the same 0.5 mm clearance per side.
- One honest note: the underside sockets have flat ceilings — a 12 mm bridge, crossed cleanly in PLA/PETG with normal part cooling. Print with supports OFF.
- Watertight/manifold mesh — slices clean in OrcaSlicer, Bambu Studio, PrusaSlicer, Cura
- Listing images are renders of the actual model geometry, not photos of a print — your Makes will be the first real photos
**Original design** — modelled from code, all rights reserved. The rest of the ForgeStack system is free on my profile too: baseplates in 3×2 and 4×4, bins in 1×2, 2×2 and a divided 2×3, a 1×1 pen cup module, a hanging bin and its wall rail — plus the Desk Cable Clip, the Modern Ribbed Planter Pot, the Stackable Storage Box and the Square Dice Tray. Every one of them support-free.
**License:** CC BY-NC 4.0 — free for personal use: print as many as you like for yourself and as gifts. No selling of prints, and no redistribution or sharing of the files.