1 / 12
Intake Fan Shroud for Lian Li O11D EVO XL — zdjęcie 1
1 / 12

Intake Fan Shroud for Lian Li O11D EVO XL

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Fan shroud for Lian Li O11D EVO XL side intake. 120/140 mm fans, 45 mm deep, no supports. Needs M5 x 15 mm screws.

Ocena
0 / 5
Polubienia
0
Pobrania
1
Wydruki
0
Wyświetlenia
11
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

WHAT TO EXPECT My build already runs cool with strong positive pressure, so the temperature drop was small: under 1 °C on the CPU under load. The bigger win is that all intake air goes through the filter. Your results will depend on your case, fans and fan curve. 

WHICH FILE
- 120 mm, any brand: 105 mm hole spacing
- 140 mm Arctic (P14, P14 Pro): 125 mm hole spacing
- 140 mm Noctua and most other brands: 124.5 mm hole spacing

Not sure? Check your fan's spec sheet for "hole spacing". The wrong 140 file is about 0.35 mm off at each screw, and the screws will catch.

HARDWARE Needed
- 12 M5 self-tapping PC fan screws, 15 mm long (12–16 mm works), 4 per shroud
- Stock 10 mm fan screws are too short: the shroud adds a 3 mm screw seat
- Screw heads must be under 9 mm across. No washers.
- #2 Phillips screwdriver with a 4 in shaft

PRINT SETTINGS
- PETG recommended (handles heat better than PLA)
- Fan side down: the face with the round opening and four holes goes on the bed


INSTALL 
1. Unplug the PC and remove the fan bracket. 
2. One fan at a time, remove its screws. Keep the fan against the bracket. 
3. Lay a shroud flat side down on the mesh side, holes lined up. 
4. Drop a screw down each corner and drive it into the fan. Snug, not tight. 
5. Refit the bracket and close the panel.

Tagi