1 / 12
Intake Fan Shroud for Lian Li O11D EVO XL — image 1
1 / 12

Intake Fan Shroud for Lian Li O11D EVO XL

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Fan shroud for Lian Li O11D EVO XL side intake. 120/140 mm fans, 45 mm deep, no supports. Needs M5 x 15 mm screws.

Rating
0 / 5
Likes
0
Downloads
1
Makes
0
Views
14
Reviews
0

Updated at source:

Model information

Category
Computers
License
Creative Commons — Attribution — Noncommercial — Share Alike

WHAT TO EXPECT My build already runs cool with strong positive pressure, so the temperature drop was small: under 1 °C on the CPU under load. The bigger win is that all intake air goes through the filter. Your results will depend on your case, fans and fan curve. 

WHICH FILE
- 120 mm, any brand: 105 mm hole spacing
- 140 mm Arctic (P14, P14 Pro): 125 mm hole spacing
- 140 mm Noctua and most other brands: 124.5 mm hole spacing

Not sure? Check your fan's spec sheet for "hole spacing". The wrong 140 file is about 0.35 mm off at each screw, and the screws will catch.

HARDWARE Needed
- 12 M5 self-tapping PC fan screws, 15 mm long (12–16 mm works), 4 per shroud
- Stock 10 mm fan screws are too short: the shroud adds a 3 mm screw seat
- Screw heads must be under 9 mm across. No washers.
- #2 Phillips screwdriver with a 4 in shaft

PRINT SETTINGS
- PETG recommended (handles heat better than PLA)
- Fan side down: the face with the round opening and four holes goes on the bed


INSTALL 
1. Unplug the PC and remove the fan bracket. 
2. One fan at a time, remove its screws. Keep the fan against the bracket. 
3. Lay a shroud flat side down on the mesh side, holes lined up. 
4. Drop a screw down each corner and drive it into the fan. Snug, not tight. 
5. Refit the bracket and close the panel.

Tags