Daiwa 1000C Spool Click Claw " Spool Clicker"
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A replacement part for the vintage Daiwa 1000C Spinning Reel. The plastic spool "clicker" underneath the spool.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 5
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Noncommercial
This is Diawa Part 7 in the attached diagram in the Documentation Below
Part Number on the Daiwa Diagram at Mike's Reel Repair is 6-030-4511
A replacement 3d Printed part for the vintage Daiwa 1000C Spinning Reel. The original plastic clicker underneath the spool breaks often and is hard to find as the reel (and parts) haven't been manufactured for decades. I bought a brand new spool off of ebay and modelled this piece off the original plastic clicker underneath the spool for my Daiwa 1000C.
Yay for my intro to 3d Modelling and Tinkercad.
Use a M2.5x5mm screw or a M2.5x6mm with a small nut/washers as spacers to hold the printed clicker in the screw hole.
Feel free to make it better. It works just good enough in my Daiwa 1000C reel. I used generic PLA to print this.