Whetstone Base for Kitchen Knife Sharpening Guide 17 Degrees
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A base that holds one thin whetstone at the right height for the Kitchen Knife Sharpening Guide 17 Degrees by Meuon.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 61
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial
What it is
This is a base for the Kitchen Knife Sharpening Guide 17 Degrees by Meuon:
https://www.printables.com/model/1800114-kitchen-knife-sharpening-guide-17-degrees
The guide needs the stone top at a set height above the surface its legs slide on. My thin stones sat too low, so the guide stood too far from the stone. Stacking two stones fixed the height, but loose stacked stones shift and rub on each other.
This base holds one thin stone up at the right height. The guide legs glide on the flat rails on each side of the stone.
Fit and dimensions
Stone size: 12 x 66.5 x 185 mm
Stone top: 21 mm above the rails
Raised stone bed: 62 mm wide, 9 mm tall
End stops hold the stone at both short ends and sit 2 mm under the stone top
Rails: 14 mm wide on each side
Overall: 193.5 x 94 x 23 mm
There are no side walls along the long edges of the stone. The guide legs run down right next to the stone, so side walls would block them.
Files
whetstone_base.stl
Print settings
Material: PETG (it gets wet)
Print flat as exported, no supports
2 walls, 12% gyroid infill
Use
Set the stone in the base between the end stops.
Place the guide over the stone with its legs on the rails.
Sharpen as normal with the guide.