1 / 3
Outlet Phone Charging Shelf – Slides Under the Socket Frame, No Screws, No Supports — zdjęcie 1
1 / 3

Outlet Phone Charging Shelf – Slides Under the Socket Frame, No Screws, No Supports

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Phone pocket below a wall socket – thin tongue slides under the socket frame. No screws, no drilling.

Ocena
0 / 5
Polubienia
1
Pobrania
0
Wydruki
0
Wyświetlenia
7
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Standard Digital File License

Charge your phone at the wall socket without leaving it on the floor or hanging by its cable. A thin tongue slides under the frame of a standard European wall socket – no drilling, no screws, no tape. Your phone stands in the pocket right below the socket while the charger stays plugged in above it.

  • No screws, no drilling: switch off the circuit, loosen the cover screw of the socket, slide the 1.6 mm tongue behind the frame (between the frame and the wall), tighten the screw again. Only the outer frame holds it – the socket itself is not touched.

  • Fits 80 mm frames: the tongue is 78 mm wide and stays under the frame; the opening above it is 72 mm wide for the socket insert (typical EU single sockets, 80–86 mm frames).

  • Phone below the charger: the top of the phone sits 3 mm under the frame, so it never leans on the charger plug.

  • Two sizes: for phones up to 155 mm tall in a case (most 6.1" phones) and up to 170 mm (6.7" / Max / Ultra / Plus).

  • Cable from below: a 16 × 9 mm slot in the bottom of the pocket lets a USB-C or Lightning plug pass through; extra cable goes around the side.

  • Fits thick cases: pocket 81 × 16 mm inside (phones up to 78 mm wide and 14 mm thick in a case), open on the sides.

  • Prints without supports: lying on its side, as in the 3MF.

  • Size: 155 version 85 × 20 × 164 mm, 170 version 85 × 20 × 179 mm.

Print settings

  • Orientation: lying on the side, as in the 3MF / STL.

  • 0.20 mm layer, PLA or PETG.

  • Bambu Lab A1, PLA, 0.20 mm (2 walls, 15% infill): 155 mm – 1 h 12 min / 41.1 g, 170 mm – 1 h 15 min / 44.1 g.

Safety: always switch off the circuit breaker before loosening the socket cover. Do not use it if the socket frame does not fully cover the tongue.

Designed from scratch by bezbajzlu.

Tagi