1 / 2
Gull Winged Rear Build Plate Stop for Voron Trident — zdjęcie 1
1 / 2

Gull Winged Rear Build Plate Stop for Voron Trident

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Gull winged build plate stop for indexing build plates lacking indexing pins. Uses PTFE tubing for heat resistance

Ocena
0 / 5
Polubienia
8
Pobrania
8
Wydruki
0
Wyświetlenia
105
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

This gull shape plate stop allows aligning the build plate on a Voron Trident when your build plate doesn't support indexing pins.

This was design to allow me to more easily line up my build plate on a 350mm bed.

While it doesn't cover the full width of the bed it does make angling the build plate and then dropping it down to align the edges more consistent

Note: This has been sized and tested for the Voron Trident R1.  I haven't tested it yet with the R2 parts.

Hardware needed

Part

Count

Note

M3x16

2

Holds the PTFE tubing with a gap so it doesn't conduct heat from the bed

M5x16

1

Replaces (1) of the current M5x10 closest to the bed on the Bed Frame

PTFE Tube (4mm OD 3mm ID)

2

Cut to preferred length. I suggest cutting a little long and trimming

The step file has been included to allow for adjustment based on your build plate or to allow somebody to remix for other printers.

Tagi