2.4G RF RD4 LED Remote Holder (BTF-LIGHTING, FOSUO and others)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holder for the RD4 2.4G RF LED remote from BTF-LIGHTING, FOSUO and other LED strip kits. VHB mount; buttons work docked.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 2
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial
A small open-front holder for the RD4 2.4G RF LED remote. It holds only the bottom of the remote, so most of the face stays clear, and the buttons work while it's docked.
Which remote
This remote comes with LED strip kits and controllers sold under many brand names, including BTF-LIGHTING (mine came with their COB strip kit) and FOSUO. Look for "2.4G RF RD4" printed under the buttons. The RDX series manual lists the RD1 to RD4 at the same size, so those should fit too.
How it works
The remote drops in from the top. Small lips on each side and a short lip at the front keep it from tipping out, and they stay clear of the buttons.
The battery tray is on the bottom end, so lift the remote out to change the coin cell.
Mounting
It's made for VHB tape on a flat, smooth surface; mine is on metal. 3M Command strips or similar would also work.
One strip of 1 in VHB across the back, near the top.
Clean the surface with isopropyl alcohol and press the holder on firmly.
VHB gets stronger over the first day.
What to Print
rd4_remote_holder.stl: the holder, already in print orientation.rd4_remote_holder_looser.stl: a slightly looser version, if the standard one is too snug..3mffiles: PrusaSlicer projects with the settings below, set up for a Prusa MINI / MINI+..bgcodefiles: sliced for the Prusa MINI / MINI+ in PLA.
Printing
PLA, 0.20 mm layers, 3 walls, 15% infill. About 8 g.
Print it upright as oriented. No supports or brim needed.
How AI Helped
This is my design. I decided what it needed to do: hold the remote on a metal surface with VHB, leave as much of the face open as possible, keep the buttons usable while it's docked, and use little filament.
An AI assistant turned my measurements into the model, checked the fit and printability, executed the renders, and chcked this description.
