1 / 3
Under-Sink Cabinet Door Pocket – Gloves, Sponge & Brush Organizer, Tape or Screws, No Supports — zdjęcie 1
1 / 3

Under-Sink Cabinet Door Pocket – Gloves, Sponge & Brush Organizer, Tape or Screws, No Supports

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Hexagon pocket for the inside of an under-sink cabinet door: gloves, sponge, brush. Drain holes, tape or 2 screws.

Ocena
0 / 5
Polubienia
2
Pobrania
3
Wydruki
0
Wyświetlenia
21
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Standard Digital File License

A tidy place for rubber gloves, a sponge and a dish brush – right on the inside of the cabinet door under your sink. Open the door and everything is at hand; close it and it is out of sight.

  • Closed hexagon pocket: flat front, 45° ends – nothing falls out at the sides, and the shape prints without any supports.

  • Drains: three diamond-shaped holes in the bottom let water from a wet sponge or gloves drip out.

  • Two ways to mount: strong double-sided tape (VHB) on the flat back, or 2 short countersunk screws 3.5–4 × 12 mm (for 16–18 mm doors). The screw holes sit in the strip above the pocket, so a screwdriver reaches them straight from the front.

  • Two sizes: S (84 mm wide) – gloves, dish brush, small or cut sponge (up to ~50 mm wide); L (110 mm wide) – also a standard kitchen sponge (65 × 28 mm) standing upright.

  • Pocket inside 32 mm deep, 60 mm tall; total 84/110 × 74 × 36 mm.

  • Before mounting: hold it against the door and close the door – keep it away from the hinges and below the sink bowl / top rail of the cabinet. Mount it in the middle of the door width.

Print settings

  • Orientation: lying on its side, as in the 3MF / STL (the width of the pocket is the print height).

  • 0.20 mm layer, PLA or PETG (PETG is better for a humid under-sink cabinet).

  • Bambu Lab A1, PLA, 0.20 mm (2 walls, 15% infill): S 84 mm – 1 h 21 min / 38.2 g, L 110 mm – 1 h 39 min / 48.0 g.

Designed from scratch by bezbajzlu.

Tagi