1 / 5
Riser Feet for Revolo Tail 2 on Xone:92 / Xone:96 — zdjęcie 1
1 / 5

Riser Feet for Revolo Tail 2 on Xone:92 / Xone:96

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Four small risers that lift the feet of the Revolo Tail 2 pedal, so it sits on its rubber feet and not on the Xone:96

Ocena
0 / 5
Polubienia
0
Pobrania
0
Wydruki
0
Wyświetlenia
12
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Music
Licencja
Creative Commons — Attribution

Small risers for the feet of the Revolo Tail 2 pedal, so it sits on its rubber feet and not on the knobs of an Allen & Heath Xone:92 / Xone:96.

THE PROBLEM
When I put my Revolo Tail 2 on my Xone:96, its feet did not touch the mixer. The pedal rested only on the knobs, so it slid every time I touched it.

THE FIX
Put one riser between each foot and the pedal. Now the pedal rests on its feet and stays in place.

SIZE
- Riser: 12 mm tall, 12 mm wide, 3.4 mm hole (for M3)
- Rubber foot: 12 mm wide, 7 mm thick 
- Total height: 19 mm (12 mm riser + 7 mm foot) 
- Tested on the Xone:96. It should also fit the Xone:92, but check the height first.

WHAT YOU NEED
- 4 x M3x20 screws (the original screws are 6 mm long, so you need longer ones) 
- 4 x M3 nuts (I put one inside each foot so the screw does not come out of the rubber)

PRINT SETTINGS 
- Print standing up
- PETG or PLA, 0.2 mm layers
- 4 walls, 50% infill or more 
- No supports 
- The plate has 4 pieces (one set)

Not affiliated with Revolo or Allen & Heath.

Tagi