Steam Frame controller elasticated wrist/knuckle straps.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Steam Frame controller elasticated wrist/knuckle straps that can easily switch between the two.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 34
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Virtual Reality
- Licencja
- Creative Commons — Attribution
This is made using the official steam frame files made available by Valve.
I didnt like fixed knuckle straps as it was hard to reach all the buttons comfortably all the time while having it tight enough that it would not slip off my hand.
So here is my first attempt at elasticated ones to hopefully allow me to have it just right.
Printed with a 0.8mm nozzle as too much hassle switching to a smaller nozzle.
Printed at 0.16mm layer height in generic PETG for its layer adhesion.
I have added some extra plastic underneath the small protrusions except the locking nub so that they do not need additional support to print.
Bought 3mm wide round elasticated cord from the local haberdashery. I would recommend taping the ends with some tape with no cord inside part of it so its easier to feed through the holes.
Currently got 50cm of cord on each controller. I will trim the excess off once i am sure i have the correct length.