1 / 9
Cannelure Paper Towel Holder, Print-in-Place Bearing — zdjęcie 1
1 / 9

Cannelure Paper Towel Holder, Print-in-Place Bearing

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Paper towel holder with fine vertical grooves. The roll sits on a plate that turns on a print-in-place bearing.

Ocena
0 / 5
Polubienia
1
Pobrania
7
Wydruki
0
Wyświetlenia
27
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

A paper towel holder that stands the roll inside a patterned sleeve. A full-height opening at the front gives you the sheet and shows how much is left.

The roll sits on a plate that turns on a print-in-place bearing, so a sheet pulls off easily.

Cannelure runs fine vertical grooves up the sleeve, above a smooth plain band at the base.

Size

130 mm of room inside, against 110 to 120 mm for a standard kitchen roll. Good for an open counter, where the holder is seen from every side.

Parts

  • Sleeve, the patterned outer body. The only part that carries the pattern.

  • Connector Pin, a hexagonal pin that locks into the base of the sleeve and the base of the spindle.

  • Rotating Plate, the plate the roll rests on. Turns freely on the spindle's bearing.

  • Spindle, the center rod the roll slides onto, with a print-in-place bearing at its base.

Assembly

  1. Push the Connector Pin into the base of the Spindle, then turn it a few times to free the bearing.

  2. Press the Spindle with its pin into the socket in the floor of the Sleeve.

  3. Slide the Rotating Plate down the Spindle with the cut-out facing down. It drops into place on its own.

  4. Drop the roll over the Spindle.

Print settings

Use the settings saved in the project file. Four of them are set per object:

  • Spindle: seam position Random

  • Spindle body and inner ring: top surface pattern Concentric

  • Sleeve and Rotating Plate: top and bottom surface pattern Concentric

  • Sleeve: sparse infill 6 percent

Optional: paint a seam line down the outside of the Spindle.

The rest: 2 walls, 10 percent gyroid infill, no supports, no brim.

Two plates: plate 1 is the Spindle, Rotating plate and pin, plate 2 the Sleeve. Run the spindle, plate and pin in a second colour if you like.

Tagi