Kodai Fruit Fly Trap, Screw-Together, No Glue
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Kitchen fruit fly trap with fine vertical ribs and a smooth Foot in a second colour. Screws together, no glue.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 33
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A fruit fly trap for the kitchen counter. Three pieces that screw together, no glue and no drilling. The Kodai pattern runs fine vertical ribs around the Base, above a smooth Foot you can print in a second colour, so it looks at home next to the fruit bowl instead of looking like lab equipment.
Fill the base to the MAX line molded inside the rim, twist the funnel on until snug, and set it out. Empty and rinse when it fills up.
Parts
Base, the patterned body that holds the bait. Fill line marked MAX molded on the inside wall.
Foot, the smooth part that screws onto the bottom of the Base. Print it in a second colour.
Support, printed with the Base, under its lower edge. Remove it after printing.
Funnel, threads onto the base and narrows to a small opening flies find easy to enter and hard to leave.
Assembly
Remove the Support from the Base.
Screw the Foot onto the bottom of the Base.
Mix the bait (see recipe below) and pour into the Base up to the MAX line.
Thread the Funnel onto the Base clockwise until snug.
Set on the counter near the fruit bowl or bin.
Bait recipe
Ingredient | Amount | Purpose |
|---|---|---|
Apple Cider Vinegar (ACV) | Fill to about 1/3 of the Base | The classic fruit fly magnet, mimics rotting fruit |
Dish Soap (liquid) | 2 to 3 drops | Breaks the surface tension so they sink |
Sugar or fruit scraps (optional) | 1 tsp sugar or a piece of banana | Extra sweetness to boost the aroma |
Dimensions
Ø52 x H78 mm assembled.
Print settings
3 wall loops, 15% lightning infill, concentric top and bottom surface. Two plates: the Base with its Support; the Foot and the Funnel, printed one after the other (sequential printing). Everything is already set in the files.