Kodai Paper Towel Holder, Print-in-Place Bearing, Two-Colour Foot
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Paper towel holder with fine vertical ribs. The roll sits on a plate that turns on a print-in-place bearing.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 62
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A paper towel holder that stands the roll inside a patterned sleeve. A full-height opening at the front gives you the sheet and shows how much is left.
The roll sits on a plate that turns on a print-in-place bearing, so a sheet pulls off easily.
Kodai runs fine vertical ribs up the sleeve, above a smooth Foot you can print in a second colour.

Size
Standard, 136 mm diameter and 240 mm high. 134 mm of room inside, against 110 to 120 mm for a standard kitchen roll. Good for an open counter, where the holder is seen from every side.

Parts
Sleeve, the patterned outer body. The only part that carries the pattern. It prints with a support ring under its base: break the ring off after printing.
Foot, the plain base the Sleeve screws into. Print it in a second colour.
Connector Pin, a hexagonal pin that locks into the base of the sleeve and the base of the spindle.
Rotating Plate, the plate the roll rests on. Turns freely on the spindle's bearing.
Spindle, the center rod the roll slides onto, with a print-in-place bearing at its base.

Assembly
Break the support ring off the bottom of the Sleeve.
Screw the Sleeve into the Foot.
Push the Connector Pin into the base of the Spindle, then turn it a few times to free the bearing.
Slide the Rotating Plate down the Spindle with the cut-out facing down. It drops into place on its own.
Press the Spindle with its pin into the socket in the floor of the Sleeve.
Drop the roll over the Spindle.

Print settings
Use the settings saved in the project file. Five of them are set per object:
Spindle: seam position Random
Spindle body and inner ring: top surface pattern Concentric
Sleeve and Rotating Plate: top and bottom surface pattern Concentric
Sleeve: sparse infill 6 percent
Foot: sparse infill pattern Lightning, top surface pattern Concentric
Optional: paint a seam line down the outside of the Spindle.
The rest: 2 walls, 10 percent gyroid infill, no slicer supports, no brim.
Two plates: plate 1 is the Sleeve, plate 2 the Foot, Spindle, Pin and Rotating Plate. Run the foot, spindle, plate and pin in a second colour if you like.
