1 / 7
ASUS Prime 9070XT Deshroud — 2× 140mm Fan Mod — zdjęcie 1
1 / 7

ASUS Prime 9070XT Deshroud — 2× 140mm Fan Mod

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Deshroud mod for the ASUS Prime 9070XT — swap the stock cooler for 2× 140mm fans. Fits 180mm or 256mm beds.

Ocena
0 / 5
Polubienia
1
Pobrania
3
Wydruki
0
Wyświetlenia
71
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Standard Digital File License

A deshroud mod for the ASUS Prime Radeon RX 9070XT, replacing the stock plastic shroud with a low-profile, open-air design cooled by two 140mm fans. The card's existing heatsink and heatpipes stay in place — this mod only replaces the shroud, giving you better airflow, lower noise, and a cleaner, more industrial look.

Key features:

  • Fits the ASUS Prime 9070XT reference heatsink/PCB.

  • Dual 140mm fan cooling instead of the stock fan shroud. Compatible with both 15mm and 25mm thick fans.

  • Available in two build plate sizes: 180mm and 256mm (pick the one matching your printer).

  • Two printed parts, consisting of a front and back half.

Print volume required: 180mm or 256mm build plate version.

Materials/components required to build this mod:

  • 7x M2x3x3 threaded inserts.

  • 2x M3x4x4.2 threaded inserts.

  • No new screws need to be purchased — the card's original screws can be reused!

  • 2x 140mm PC fans (up to 25mm thick). Arctic P14 (Slim or Normal) PWM PST or better recommended.

PC Components required/recommended:

  • ASUS Prime Radeon RX 9070XT graphics card (stock cooler removed, heatsink/heatpipes reused). The screw secured with the warranty-void sticker, and the backplate, never need to be removed — so the warranty stays intact and the card can be returned to its original, stock condition without a trace.

  • 2x 140mm PC fans (up to 25mm thick). Arctic P14 PWM PST.

Additional info:

  • This mod reuses the card's factory heatsink and heatpipes — only the plastic shroud and stock fans are replaced.

  • The fans extend beyond the heatsink fins, which also helps overall case airflow — fresh air drawn in from the bottom of the case reaches that area too.

  • Connect the fans to a motherboard fan header and control them from there. Using FanControl software is recommended: https://getfancontrol.com

Printing instructions:

  • Minimum print volume required: see dimensions above (pick the 180mm or 256mm build plate version matching your printer).

  • Recommended material: PETG. ABS and ASA also work.

  • Recommended layer height: 0.2-0.25mm.

  • 18% infill / 4 walls / 4 top-bottom layers.

  • No supports needed.

License summary:

📄 License: Personal use only

✅ You CAN print and use this for yourself, and share photos of your build

🚫 No reselling of prints or the design

🚫 No sharing/reuploading the files

🚫 No remixing or modifying for redistribution

Full terms in the license section below.

Tagi