ASUS Prime 9070XT Deshroud — 2× 140mm Fan Mod
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Deshroud mod for the ASUS Prime 9070XT — swap the stock cooler for 2× 140mm fans. Fits 180mm or 256mm beds.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 3
- Makes
- 0
- Views
- 83
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Standard Digital File License
A deshroud mod for the ASUS Prime Radeon RX 9070XT, replacing the stock plastic shroud with a low-profile, open-air design cooled by two 140mm fans. The card's existing heatsink and heatpipes stay in place — this mod only replaces the shroud, giving you better airflow, lower noise, and a cleaner, more industrial look.
Key features:
Fits the ASUS Prime 9070XT reference heatsink/PCB.
Dual 140mm fan cooling instead of the stock fan shroud. Compatible with both 15mm and 25mm thick fans.
Available in two build plate sizes: 180mm and 256mm (pick the one matching your printer).
Two printed parts, consisting of a front and back half.
Print volume required: 180mm or 256mm build plate version.
Materials/components required to build this mod:
7x M2x3x3 threaded inserts.
2x M3x4x4.2 threaded inserts.
No new screws need to be purchased — the card's original screws can be reused!
2x 140mm PC fans (up to 25mm thick). Arctic P14 (Slim or Normal) PWM PST or better recommended.
PC Components required/recommended:
ASUS Prime Radeon RX 9070XT graphics card (stock cooler removed, heatsink/heatpipes reused). The screw secured with the warranty-void sticker, and the backplate, never need to be removed — so the warranty stays intact and the card can be returned to its original, stock condition without a trace.
2x 140mm PC fans (up to 25mm thick). Arctic P14 PWM PST.
Additional info:
This mod reuses the card's factory heatsink and heatpipes — only the plastic shroud and stock fans are replaced.
The fans extend beyond the heatsink fins, which also helps overall case airflow — fresh air drawn in from the bottom of the case reaches that area too.
Connect the fans to a motherboard fan header and control them from there. Using FanControl software is recommended: https://getfancontrol.com
Printing instructions:
Minimum print volume required: see dimensions above (pick the 180mm or 256mm build plate version matching your printer).
Recommended material: PETG. ABS and ASA also work.
Recommended layer height: 0.2-0.25mm.
18% infill / 4 walls / 4 top-bottom layers.
No supports needed.
License summary:
📄 License: Personal use only
✅ You CAN print and use this for yourself, and share photos of your build
🚫 No reselling of prints or the design
🚫 No sharing/reuploading the files
🚫 No remixing or modifying for redistribution
Full terms in the license section below.