1 / 6
Probe Holder Inner Side for Geeetech Prusa i3 SkyNet3d Firmware
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
So I had the problem, that my Prusa i3s sled was slightly bend and the original z probe holder was too far away from…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 209
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution
So I had the problem, that my Prusa i3s sled was slightly bend and the original z probe holder was too far away from my nozzle. So the nozzle crashed into the bed continuously.
I designed this thing to get the z probe holder closer to the nozzle.
You need to change your screws, the original ones are too short.
You also need to change your x endstop mount. See the picture for example.
Note: This only works with the 4mm sensor, the 8 mm sensor is too big.
Category: 3D Printer Parts