Boosted Board Remote Wall Mount

I basically wanted a wall mount for my Boosted Board remote where the charging cable would automatically slide into the remote. Additionally the leash just slides through a channel to the bottom. The charging cable can be zip tied to the bottom part of the mount.

Update:

I was not really happy with the original design of the charging cable mount. Therefore I slightly redesigned the zip tie attachment to a single plane to the back of the cable. With two zip ties tensioned really tough with two tongs, the cable sits in place pretty well now. Also I adjusted the model so that I could print it without any support and made it a bit stiffer overall.

Print Settings

Printer Brand:

Monoprice

Printer:

Rafts:

Yes

Supports:

Notes:

~~I printed the mount with the charging port at the bottom. By doing this I avoid having support material inside of the model which would probably be pretty complicated to be removed later on.~~

I printed the mount with the opening for the remote towards the build plate. The model should be rotated correctly already. The model came out great without any supports but I used a raft because my white filament does not stick really well to my glass bed.

Category: Organization